Carefully selected composition of bitumen binder gives a wide range of required operation features to AQUAIZOL materials.
Roofing and waterproofing materials of the AQUAIZOL trademark have been produced serially since August 1999. Carefully selected composition of bitumen binder gives the required operating characteristics to a wide range of materials. Reinforcing basis of glass fibre or polyester - does not rot and aging. The upper layer of material is protected by the shale dressing compound.
Type of modifier defines the extremely low temperature at which it is possible to lay and store the material on the roof during installation while keeping the flexibility on rolls unwinding, as well as the extremely high temperature at which the material retains its physical and mechanical properties.
SBS – modified materials allow laying at temperatures up to -20°C and keep the physical and mechanical properties when heated to +105 °C.
APP – modified materials (with dressing compound) permit laying at temperatures up to -12°C and keep the physical and mechanical properties when heated to +115°C, and APP-modified material (without dressing compound) when heated to +110°C.
The choice of materials by the type of the reinforcing basis (fiberglass or polyester) is determined primarily by the construction of the roof and the parameters of its operation. Glass reinforced materials are typically used on flat roofs or roofs with a slope of not more than 4%, as fiberglass is not flexible and the material can be broken in the direction of deformations if it was possible of the structures of the roof to deform. On the roofs of the industrial buildings with arched trusses, the presence of joining and “flagons” (roof fractures), the possibility of vibrations via the crane loads and the work of the equipment it is necessary to use the materials reinforced by polyester as these materials allow the elongation up to 30-40%.
When construction of a new roof (from the covering) it is necessary to perform the primering of the covering (primer). Normative set of materials is - the lining 2,5, top layer - 4,0-PS. When repairing a roof without removing the old mat it is allowed to use materials -4,0-PS. Depending on the requirements for the roofs it is necessary to use the following AQUAIZOL brands of materials for the construction of the roof mat:
Aquaizol ECO lining is the padding bitumen- polymer material with the reinforcing basis of glass fibre (GF) or polyester (PE) designed for the lower layer of the roof mat. The covering mass consists of the distilled bitumen modified by the atactic polypropylene (APP). On both sides of the material there is a polyethylene film. Roll width is 1 meter, length is 15 meters.
Aquaizol ECO is the padding bitumen- polymer material with the reinforcing basis of glass fibre (GF) or polyester (PE), designed for the top layer of the roof mat. The covering mass consists of the distilled bitumen modified by the atactic polypropylene (APP). Material upper surface is protected from the mechanical impact and UV by shale dressing compound, and the bottom surface of material is applied with the plastic film.
Roll width is 1 meter, length is 10 meters.
Aquaizol APP lining is the padding bitumen- polymer material with the reinforcing basis of glass fiber (GF) or polyester (PE) designed for the lower layer of the double-layer roof mat and waterproofing of elements of buildings and structures. The cover consists of a mass of distilled bitumen modified by the atactic polypropylene (APP). Both sides of the material are applied with the plastic film.
Roll widths is 1 meter, length is 15 meters.
Aquaizol APP is the padding bitumen- polymer material with the reinforcing basis of glass fiber (GF ) or polyester (PE), designed for the top layer of the roof mat. Mechanical impact and UV protected material upper surface shale grit. The lower surface is covered with a release polyethylene film. As bitumen modifier used atactic polypropylene (APP).
Roll widths is 1 meter, length is 10 meters.
Aquaizol PRO is an advanced, weld-on, bitumen-polymer material with a reinforcing base made of polyester (PE), intended for the device of the upper layer of roofing carpet. The upper surface of the material is protected from mechanical stress and ultraviolet radiation with coarse-grained dressing. The lower surface is covered with anti-adhesive polyethylene film with a corporate logo.
Atactic polypropylene was used as a bitumen modifier.
Roll width 1 meter, length 10 meters.
The material has an increased warranty period of 25 years!
Aquaizol SBS lining – is a fused bitumen-polymer material with reinforcing basis of glass fiber (GF) or polyester (PE); designed for the lower layer of the double-layer roof mat and waterproofing of elements of buildings and structures.The cover consists of a mass of distilled bitumen modified by styrene-butadiene-styrene (SBS). Both sides of the material are applied with the plastic film.
Roll widths is 1 meter, length is 15 meters.
Aquaizol SBS – padding bitumen-polymer material with reinforcing basis of polyester (PE) designed for the top layer of the roof mat. The upper surface is protected from mechanical impact and UV by the shale dressing compound. The lower surface is covered with a polyethylene film. Styrene -butadiene -styrene (SBS) is used as bitumen modifier.
Roll widths is 1 meter, length is 10 meters.
Aquaizol ELAST – padding bitumen-polymer material with reinforcing basis of polyester (PE) designed for the top layer of the roof mat. The upper surface is protected from mechanical impact and UV by the shale dressing compound. The lower surface is covered with a polyethylene film. Styrene -butadiene -styrene (SBS) is used as bitumen modifier.
Roll widths is 1 meter, length is 10 meters.
Aquaizol - waterproofing - padding bitumen- polymer material with reinforcing basis of reinforced polyester; designed for waterproofing foundations of buildings and structures. The covering mass consists of distilled bitumen modified with styrene- butadiene- styrene (SBS).
Roll width is 1 meter; length is 10 meters.
All roofing materials, produced by the AQUAIZOL Roofing Membranes Factory are the subjects of annual UkrSEPRO certification.
Warranty period is 20 years.
Physical and mechanical properties of AQUAIZOL materials
Materials | Without dressing compound | With dressing compound | |||||||
Roll size | 15х1 | 10х1 | 10х1 | ||||||
Weight 1 sq.m., kg | 2,5;3,0 | 3,0 | 2,0; 2,5; 3,0 | 3,0; 3,5;4,0 | 4,0 | 4,0 | 3,5; 4,0; 4,5 | 4,0; 4,5 | 4,5; 5,0;6,5 |
Modification | APP | SBS | APP | SBS | APP | SBS | APP | APP | SBS |
Heat resistance | +100 | +105 | +110 | +110 | +100 | +105 | +115 | +115 | +110 |
Flexibility on a bar | -12 | -15 | -12 | -20 | -12 | -15 | -12 | -13 | -20 |
Top protective cover | polyethylene film | slate/basalt gritting | |||||||
Watertightness | Absolute |